Bobbie 2.0: The robot does not finish its program.

1. First, check if the backup battery is fully charged.
   If not, the robot will stop in the middle of its program.
2. It is important to place the robot far enough (30cm) from the edge on the window.
3. Make sure the cloth does not stick out beyond the robot. If this is the case, the sensors will not work and the robot will not come off the side / be able to turn.

If the robot still does not clean the entire window after this, it is important that you clean your window thoroughly yourself before using the robot. It may be that the window has been dirty for too long, causing the robot's rubber tracks to become too dirty and thus make less good contact. It is also important to then check whether the rubber tracks of Bobbie are clean. Clean them by following the steps below;

1, Turn off the robot
2, Press and hold one of the detection corners under the robot
3, turn on the machine, wait 10 seconds, the belt will rotate automatically
4, Wipe the belt with a damp cloth